Floppy and Tape Emulators

Shop Floor has arange of emulator units for your shop needs. Our emulators units can be used for day in and day out commincations. Our Tape Emulator will alow you to get ride of your paper tapes. Our Floppy emulator will alow you to get ride of the outdated floppy disk.

Floppy and Tape Emulators

Floppy Emulator

    - Floppy Drive Emulator

• Plug and Play Installation
• 720k/1.44MB capacity IBM
• 28 or 32 pin ribbon cables systems

Easy installation and no system configuration or debugging required. The drive emulates your existing floppy drive to act as if the floppy drive was never removed. This drive should replace most any existing 720k/1.44MB capacity IBM format floppy drive. Also 28 or 32 pin ribbon cables systems available and will connect to your existing power and data cables. Not only will this device work in PCs but, it will also work in CNC machinery (Haas, Centroid, Robots, Flame Cutters, Greco Disks) or devices that still use floppy drives. This device completely replaces the universal floppy drive of computerized system. If you not certain this device will work in your equipment, then just ask!

Tape Emulator

    - BTR Cards

• Plug and Play Installation
• Open Architecture Design
• Universal BTR Design
• Expanded Memory
• 675 Tape Reader and Tape Punch Compatible
• 675 NC and CNC Compatible

Shop Floor BTR's eliminate the necessity of paper tape usage on NC and CNC machines. Shop Floor BTR's add an RS-232 or RS-422 port to your existing NC and CNC machines allowing sending, receiving, and drip feeding large NC or CNC

Shop Floor BTR's include all required tape reader cables/connectors, installation manual, basic communication software for setup and power supply if required. Punch cables are optional and sold separately.

request more information